Custom Single Speed 29er
I had wanted to build this one for a while; fitting it inbetween other projects means that it has been about five months in the making, but finally realised! Mostly about performance, but a little bit focused on the aesthetic and styling too. The goal was a very clean look, hence the integrated seatmast (with a Thomson seatpost modified with an internal wedge - seat height is adjustable by removing the saddle), fully internal hydraulic hose routing (the front hose enters under the stem, goes down the steerer tube, into the left fork leg and exits by the caliper. The rear hose enters the downtube behind the headtube, runs underneath the BB inside the frame before passing inside the chainstay to arrive at the brake) and one piece steerer-stem-bar. The curved seattube allows for short chainstays with the 29" wheels, and careful shaping of the stays gives clearance for the 2.25" tires and the Gates belt drive ring. A Niner Eccentric bottom bracket enables tensioning of the belt, whilst a custom split dropout allows it to be fitted to the frame. Post mounts front and rear for the disc brakes, with 140mm rotor rear, 160mm front. Assymmetric seatstays to clear the rear brake caliper.
The parts are a balance of durability and weight, with 28h Chris King single speed disc hubs laced to Edge XC rims with Sapim cx-ray spokes, Race Face Zeus SL cranks and SRAM XX brakes. Total weight is 18.5lbs.